Digital rapids TouchStream Guide de l'utilisateur télécharger pdf (Page 37)

Digital Rapids TouchStream

Page 33

3. Attach the cover to the chassis with the screws removed earlier, and tighten

them firmly.

4. Connect all external cables and the AC power cord(s) to the system.

A microprocessor and heat sink may be hot if the system has been running. Also,

there may be sharp pins and edges on some board and chassis parts. Contact

should be made with care. Consider wearing protective gloves.

Danger of explosion if the battery is incorrectly replaced. Replace only with the

same or equivalent type recommended by the equipment manufacturer. Dispose

of used batteries according to manufacturer‘s instructions.

The system is designed to operate in a typical office environment. Choose a site

that is:

 Clean and free of airborne particles (other than normal room dust).

 Well ventilated and away from sources of heat including direct sunlight.

 Away from sources of vibration or physical shock.

 Isolated from strong electromagnetic fields produced by electrical devices.

 In regions that are susceptible to electrical storms, we recommend you plug

your system into a surge suppresser and disconnect telecommunication lines

to your modem during an electrical storm.

 Provided with a properly grounded wall outlet.

 Provided with sufficient space to access the power supply cord(s), because

they serve as the product‘s main power disconnect.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Digital rapids TouchStream Guide de l'utilisateur Page 37